Garage door won't close: sensor repair in Greenwich

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (475) 897-5073

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Greenwich, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Greenwich

In Old Greenwich and Riverside, close to the Sound, salt air settles on the sensors and their brackets rust at the floor. In Cos Cob and Byram, tight older garages double as storage, and the beam is blocked by whatever was put down last. In the backcountry, long driveways and large custom doors bring a different problem: sloped or heaved slabs leave the two sensors at different heights, and landscape crews with blowers send leaves and mulch into the opening every week. In Glenville and central Greenwich, low winter sun down an east-west street can blind a sensor for half an hour a day. If the door misbehaves at the same time daily, that is the reason.

The usual reasons a door reverses or stays open

  • Misaligned photo-eyes. A bin, a bike tire or a broom knocks one bracket a few degrees and the beam misses.
  • Dirt, cobwebs or condensation on a lens. The sensor sees it as an obstacle.
  • Low sun shining straight into the receiving eye. It happens at the same hour each day and clears up later.
  • Damaged sensor wire. Staples, rodents and corrosion all break the thin low-voltage wire.
  • Close limit or force out of adjustment. The door reaches the floor and the opener reads it as a collision.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Greenwich

  • Cos Cob: Between the Mianus River and Long Island Sound. A mix of mid-century houses and renovations, many with attached garages and rooms above them.
  • Riverside: The old Mianus Neck farming and fishing community, now family neighborhoods near the water. Coastal air is hard on door hardware here.

See the full Greenwich service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (475) 897-5073
Call (475) 897-5073